Sandstone Column Wrap Cap Installation

Updated on May 23, 2024

Follow the directions below to start installing your new Sandstone Column Wrap Cap. If you have any questions please submit us a request for more information using our instant answer pop-up.

The Sandstone 18″ Column Wrap Cap is designed to fit the Slatestone 30″
Column Wraps or Columns made with Interlocking Outside Corners.

Screw Attachment

Drive one screw per side at an angle through the bottom lip of the cap all the way into the substrate. Do not over angle the screws so they don’t run through the top of the cap. Do not overdrive screws.

Adhesive Attachment

Step 1

If the top course ends with the screw hem attached: Place adhesive in each corner of the cap and secure. (fig. 1).

Step 2

If the top course ends with the screw hems cut off, face screw each piece 1” from the top so that the cap covers the screw heads. Place adhesive on inside cutouts of cap as shown (fig. 2).

Was this document helpful?

Canadian distributor of Nextstone™


Our Commitment

Nextstone is dedicated to superior product quality and exceptional customer service, ensuring your home’s aesthetic is enhanced with our stonework. Experience unrivaled excellence with Nextstone—where your satisfaction is our priority.

How Can We be of Assistance?

© 2024 -NextStoneTM. All Rights Reserved

Connect With Us

Tel: 303-371-8232  |  TF: 1-866-371-8232

Fax: 720-294-0221

PO Box 39914 – Denver, CO 80239

© 2024 -NextStoneTM. All Rights Reserved