Sandstone Inside Corners Installation

Updated on April 10, 2024

Determine how you plan to finish the corner as this will dictate the length of the corner. Corners can be capped with ledger or ledger corners. For a ledger finish, the top of the corner (the end with the lip on top) should be 1 ⅝” below the top of the flange on the top panel.

Step 1

Place corner so that the bottom of the corner will be flush with the bottom of the bottom panel. Screw thru the recessed channel at the top, bottom and middle of each side of the corner using at least a 4 ½” screw. Adhesive maybe applied to the blocks on the back side of the corner, if appropriate for the installation.

Step 2

If more than one length of outside corner is required, stack the corners by locking the male end at the top of the corner to the female end on the bottom of the corner.

Note: Sandstone Accessories are universal and can be used with all panel profiles

Optional Install: Corners can be face screwed to attach but must be filled in with grout and painted over to conceal screw heads.

Was this document helpful?

Canadian distributor of Nextstone™

Sample Rebate Requirements

Please fill out the information below. You will receive an email from the Nextstone Corporate Office asking you to submit proof of purchase of the Nextstone product (not samples) from your retailer or dealer spending a minimum of $200.00 within 30 Days of the sample purchase. Upon verification, rebates will be processed. Rebate transaction may take up to 30 days for processing. 

NextStoneTM

Our Commitment

Nextstone is dedicated to superior product quality and exceptional customer service, ensuring your home’s aesthetic is enhanced with our stonework. Experience unrivaled excellence with Nextstone—where your satisfaction is our priority.

How Can We be of Assistance?

© 2024 -NextStoneTM. All Rights Reserved

Connect With Us

Tel: 303-371-8232  |  TF: 1-866-371-8232

Fax: 720-294-0221

PO Box 39914 – Denver, CO 80239

© 2024 -NextStoneTM. All Rights Reserved