Sandstone Ledger Installation

Updated on May 17, 2024

The Sandstone Ledger is an ideal transition when using other building materials above or around NextStone™ products. It also provides a sloped sill for water runoff in wainscot type of applications.

Step 1

Measure the total length of ledger required in Linear feet. It is important to end all Ledger applications with factory finished ledger ends. If cuts must be made to meet linear coverage, cut ledger pieces in the center as this will allow tight union between the pieces with finished edges.

Step 2

Toe Screw the Ledger to the underlying substrate with screws placed at a minimum of 16″ apart. Ledgers can also be attached by screwing underneath the ledger piece. Angle screw at each end to insure tight fits between ledger pieces.

Note: Exterior applications require flashing if other siding products are used above the ledger. Flashing will also cover screws used to attach the ledger for a more professional result. If flashing will not be used, fill screw holes with grout and paint.

Was this document helpful?

Canadian distributor of Nextstone™

NextStoneTM

Our Commitment

Nextstone is dedicated to superior product quality and exceptional customer service, ensuring your home’s aesthetic is enhanced with our stonework. Experience unrivaled excellence with Nextstone—where your satisfaction is our priority.

How Can We be of Assistance?

© 2024 -NextStoneTM. All Rights Reserved

Connect With Us

Tel: 303-371-8232  |  TF: 1-866-371-8232

Fax: 720-294-0221

PO Box 39914 – Denver, CO 80239

© 2024 -NextStoneTM. All Rights Reserved