Sandstone Ledger Outside and Inside Corners Installation

Outside and Inside Ledger Corners can be used for a faster, miter free installation. Theses pieces are molded for 90˚ angles.

Simply place the Ledger Inside or Outside Corner over the top of the corner using the “v” groove. If the corners have been cut for height, use the bottom surface of the Ledger Corner. Toe screw as with the Ledger.

Note: If the Ledger is used to go over the top of an outside or inside corner accessory, a compound miter is required. This can be achieved using a chop saw or radial arm saw. Place the ledger on the saw table with the back of the ledger flush against the fence (just the way it sits when applied), and make a 45° miter cut. The corner will then require caulking and NextStone™ touch-up paint.