Sandstone Outside Corner Installation

Determine how you plan to finish the corner as this will dictate the length of the corner when using bold Sandstone Outside Corners versus Interlocking Corners. Corners can be capped with ledger or ledger corners.

Step 1

Cut 6 pieces of plumbers strap approximately 6″ long. With the corner upside-down so that the “stair-step” blocks are exposed, attach the strap to the top block on the left side so that it extends out at a right angle to the corner. The same should be done to the 3rd block, the bottom block, and finally to the same three blocks on the right side.

Step 2

Apply the corner so that the bottom of the corner lines up with the bottom of the first panel. Screw through the end of the strap into the structure.

Step 3

If more than one length of outside corner is required, stack the corners by locking the male end at the top of the corner to the female end on the bottom of the corner.

Note: Sandstone Accessories are universal and can be used with all panel profiles

Optional Install: Corners can be face screwed to attach but must be filled in with grout and painted over to conceal screw heads.